Recording Controls (Live Screen)

The system will record automatically whenever welding current is detected. All three videos are recorded: close-up, wide-view and volt-amps graphs.

In addition, the Live mode screen provides controls to manually start and stop recording, circled below:

Live Screen with Manual Record Buttons Circled

Live Screen with Manual Record Buttons Circled

Use these buttons to immediately start and stop recording of the full set of video and audio sources.

1 Minute – start recording and stop after 1 minute
5 Minute – start recording and stop after 5 minutes
Stop – stop the current recording

This recording is in addition to the automatic recording that occurs whenever an arc is detected. If you have started manual recording, and then light the arc, video will be recorded until the arc stops independent of the time interval. Recording will continue after the arc stops for the remaining time selected.

Note: the menu controls around the UDR welding image are not active, and cannot be used from this software.

PrevBtn2NextBtn2

Return to Training Software Overview

2016@VisibleWelding.com
7 Sears Road, Wayland, MA 01778-2101
+1-508.358.5775